Piles & Foundations Monitoring.png

How We Help You in Piles & Foundations Monitoring

With GEL Instrumentation engineers monitor foundations that are designed on assumptions. Load, strain, settlement and movement measurement shows how piles and foundations are actually performing during load testing and construction. This provides measured evidence to support assessment as foundation conditions and loading change.

Strain gauges measure strain along the pile and in structural elements. Load cells measure applied and residual load directly. Extensometer systems measure deformation and changes in distance between anchor points where the test or monitoring design requires it. These measurements provide different views of foundation behaviour under loading.

A load test produces a large amount of data in a short window, so acquisition matters as much as the sensor. Data loggers are configured for the test sequence, and readings are brought into Convue for review and reporting. This keeps test data organised against the design intent and monitoring requirements.

FAQs

  • How is a pile instrumented for a static load test?
    Gauges are attached to the reinforcement cage before concrete is placed. Rebar variants within the Strain Gauges family are positioned at levels set by the test design so load transfer down the shaft can be resolved. Cage instrumentation cannot be retrofitted, so positions are agreed before the pile is cast.
  • With a pressure cell at the toe alongside strain measurement up the shaft. Pile tip variants within the Pressure Cells family measure load arriving at the pile base, and comparing it against shaft strain shows how load is being shared. This is the measurement most load tests are designed to produce.
  • Considerably faster than long-term monitoring. A test that runs across hours needs acquisition configured for the load increments and hold periods, not a daily interval. We configure the logger for the test sequence and the reporting that follows it.
  • Yes, and on many projects it should. The same strain gauges and settlement sensors can be read through construction as the structure above takes load, which shows whether performance matches what the test predicted. Acquisition is simply reconfigured to a long-term interval.
  • Where excavation, dewatering or seasonal change affects the ground, yes. Vibrating Wire Piezometers track pore pressure around the foundation, which matters because effective stress in the supporting ground changes with it. This is usually installed alongside the settlement points.

Discuss Your Piles & Foundation Monitoring With GEL Instrumentation Engineers

Tell us the pile type, the test regime and what has to be demonstrated. Our engineers will configure the instrumentation and the acquisition around it.